基于ARM和GPRS的远程数据传输监测系统-检测技术与自动化装置专业论文.docxVIP

Subject :Based on the ARM and GPRS remote data transmission monitoring system Specialty : Detection Technology and Automation Equipment Name : Ma Shanqiang (Signature) Instructor: Song Bai (Signature) ABSTRACT Coal is an important basis for energy and materials, accounting for more than 70 percent of Chinas total energy. However, the coal industry, production safety situation is not optimistic about the gas explosion as a prominent representative of serious accidents have occurred.Therefore, the state gas sensors on the mine detection requirements cyclical, in order to reduce the occurrence of security incidents. Based on a series of industry standards for coal mine gas sensors from the State Administration of Work Safety,working hours of the gas sensor signal output values have been tested mine with the industry standard for data comparison and then determine whether the sensor is qualified, and remote data transmission. It can easily and quickly complete the station of calibrating coal mine gas sensors, and guarantee the security in coal mine production. This paper implements a slave device of the calibrating system on ARM9,and host PC program of the calibrating system on VC++6.0, based on the study of principle in calibrating coal mine gas sensors. The hardware of slave device of the calibrating system is divided into three parts: Power supply, Signal process and Master part. Each part can be also contained of different circuits. Power supply part is divided into Sensor power supply, Main circuit power supply, and The master chip and memory chip power supply. Signal processing part is contained by the signal Acquisition circuit, the signal Processing circuit, the signal Storage circuit and signal Transmission circuit. Master part had two circuits: both Master chip circuit and Controlled gate circuit. The program of the slave device is programmed under ADS（ARM Developer Suit）that is matched with the main chip S3C2440. The design of the system software is divi