建筑构件防火性能防火时效测试报告书.DOCVIP

PAGE 第 PAGE 2頁/共 NUMPAGES 2頁 國立成功大學防火安全研究中心驗證部門 國立成功大學防火安全研究中心驗證部門 Department of Certification Fire Protection and Safety Research Center National Cheng Kung University 附錄附錄驗證登錄商品檢驗標識圖式繪製方法 附錄 附錄 Method of Drawing Certification Mark and Registration Number 一、依標準檢驗局商品檢驗標識使用辦法規定辦理。 This drawing is regulated according to the Regulations Governing Commodity Inspection Mark of BSMI. (一)檢驗標識圖示繪製方式: Drawing Method of the Certification Mark: (二)不予指定固定尺寸，但應以適當(方格子)比例大小標印於產品本體上。 There is no size restriction on the Mark, but the Mark shall be affixed to the body of the product in appropriate proportion (please see mark in grid). (三)由報驗義務人自行印製之驗證登錄商品檢驗標識，應使用不易變質之材質製作，內容清晰可辨且不易磨滅，並以永久固定方式標示。 The obligatory inspection applicant shall use non-degenerate materials to print/produce the certification mark, which shall be affixed to each product in a visible, legible, indelible and immovable manner. (四)商品之其他標示不得與驗證登錄商品檢驗標識混淆，或使消費者不易辨別商品檢驗標識。 The affixing of other markings on the product, which are likely to mislead or confuse the consumers or the third parties, shall be prohibited. (五)驗證登錄商品檢驗標識應標示於商品本體。但商品本體太小無法標示時，得依下列方式標示之： The Certification Marking along with the registration number must be affixed to the body of the product. However, if the product is too small to accommodate the Mark, the Certification Mark along with the registration number shall be affixed in accordance with the following ways. 1具有包裝者，於最小單位包裝標示之。 If the product has its packaging, it shall be affixed to its smallest package. 2無包裝或其包裝不適宜標示者，以繫掛方式標示之。 If the product has no packaging or it is not appropriate to affix the Mark on the packaging, it may be attached to the product by hang tags. 3包裝標示或繫掛均不適宜者，置放於包裝內。 If the ways of affixing to the packaging and hang tags are not appropriate, it shall be put inside the packaging. 4以其他經標準檢驗局核准之方式標示之。 Other ways approved by the BSMI. 前項標識，應標示於商品明顯處，使消費者於購買或使用時能清楚識別。 The Certification Mark should be affixed at a conspicuous location on the product in order for the con