基于CPLD的FTU遥测系统的研究与实现-通信与信息系统专业论文.docxVIP

Subject ：Research and Implementation of FTU Telemetry System Based on CPLD Specialty ：Communication and Information System Name ：Fu Xing （Signature） Instructor：Liao Xiaoqun （Signature） ABSTRACT The feeder terminal unit is the main device of Distribution feeder automation systems. It is mainly used to accomplish real-time monitoring of the switch on the column, monitor the operation of the distribution system, provide a variety of parameters and rapidly implement the orders issued by the master, and complete telemetry, remote, remote control, fault detection. The real-time of data is essential and the amount of data processing is very large. Without increasing the peripheral circuits and dedicated large-capacity cache chip, Using CPLD realization of telemetry can greatly enhance the information transfer rate and improve the information transmission performance. It provides a viable solution to solve the problem of real-time monitoring and fault detection. Therefore, as one of the key technologies, telemetry system based on the CPLD has been used in the distribution feeder automation systems to meet the needs of real-time monitoring. This thesis investigates several issues related to this hot topic, the main research results are as follows: The circuits in the telemetry system are analyzed. It includes sampling control circuit, the frequency measurement circuit, divider circuit and the network interface circuit. Then, this thesis gives hardware circuit design and software design, accomplishes the simulation test of the four circuits, and analyzes Systematic errors. The thesis designs the hardware circuit design of telemetry system based on DSP and CPLD hardware platform. It introduces hardware circuit design of the overall system, gives the hardware circuit block diagram of the telemetry system, and designs internal logic module of every circuit. It also puts forward a program which uses CPLD to complete telemetry. It describes the software design process of tele