基于某以太网地防火报警系统测控杨龙.doc

实用标准 实用标准 精彩文档 精彩文档 实用标准 精彩文档 毕业设计（论文） 题 目： 基于以太网的智能防火报警系统软件设计 学 院： 电子信息学院 专业班级： 测控07级1班 指导教师： 宋玉琴 职称： 副教授 学生姓名： 杨龙 学 号： 40603020105 精彩文档 实用标准 摘 要 随着现代化建设的飞速发展以及人民生活水平的不断提高，人们对其住宅的要求也越来越高，表现在不仅希望居室温馨、舒适，而且对其安全性、智能化方面也提出了更高的要求。现代家庭用火、用电量正在逐年增加，家庭火灾发生的频率越来越高，火灾烟雾报警器也随之被广泛应用于各种场合。就此研制了基于AT89S52单片机的防火报警网络系统。该系统在各个火警布控点设置了独立的监控设备,并通过以太网交换信息。 本论文中主要报警器系统各个组成部分进行了介绍，对它的主控电路和外围设备电路之间的接口技术，还有软件方面进行了重点介绍。详细介绍了系统的软件设计,同时给出了电路原理图和程序流程图。实际运行证明:系统可靠性高、反应灵敏、工作速度快,具有很好的实用价值。最后通过硬件和软件实现了各个功能模块，通过对系统的误差分析，给出了系统的改进方案。相关部分附有硬件电路图。 关键字：防火报警 ，AT89S52 ，以太网 ABSTRACT With the rapid development of modernization and great improvement of peoples living, the need of house has been changed from only the living space to multiform needs of high-quality, multi-function, safety, intelligence and so on. With the modern home with fire, electricity consumption increases, the frequency of home fires is getting higher and higher. Smoke detectors have also been widely used in various occasions. Therefore, AT80S52 single 2 chip microprocessor based networked fire alarm system is developed. A independent monitoring device is distributed into each fire monitoring site and information is exchanged through Ethernet in this networked system. The main thesis of the alarm system for the various components are introduced, its control circuit and peripheral equipment circuit interface between technology and software have been the focus of introduction. System software design are described detailedly,and the circuit diagram and program flowchart are given. The system features high reliability, sensitive response and fast operational speed in its practical operation, resulting into useful value. Finally, has realized each functional module through the hardware and the software, through to systems error analysis, has given systems improvement program.