大型火电厂变压器分支零序保护误动案例分析 好文.pdfVIP

第 38 卷 第 23 期 电力系统保护与控制 Vol.38 No.23 2010 年 12 月 1 日 Power System Protection and Control Dec. 1, 2010 大型火电厂变压器分支零序保护误动案例分析 1 2 1 张 柳 ，解奎元 ，王丽君 （1.沈阳工程学院继电教研室，辽宁 沈阳 110036；2.广东国华粤电台山发电有限公司设备部，广东 台山 529228） 摘要：通过一则启备变和高厂变分支零序过流保护同时动作的实际案例，分析了两者分支零序过流保护同时动作的特殊性及 整定时需要考虑的问题，提出启备变高厂变分支零序过流保护在整定计算时，不仅需要按照相关规程和标准规定的方法进行 整定计算，而且要结合现场实际情况和一次接线方式进行深入研究，诸如分支开关击穿后的特殊情况等等。该厂3-5号600 MW机组启备变和高厂变进行整定和校验时取分支零序过流保护灵敏度系数为3，确保了保护动作的正确性，达到了优化保护 定值，提高保护动作可靠性的目的。 关键词：分支零序（过流）保护；接地方式；整定计算；跳闸；案例分析 Case study on maloperation of transformer branch zero-sequence protection in large thermal power plant 1 2 1 ZHANG Liu , XIE Kui-yuan , WANG Li-jun (1. Relay Teaching, Shenyang Institute of Engineering, Shenyang 110036, China; 2. Equipment Division, Guangdong Guohua Yuedian Taishan Power Co., LTD, Taishan 529228, China) Abstract: Through the practical case of simultaneous motion of branch zero sequence over-current protection of start up/ standby transformer and that of HV station transformer, this paper analyzes the particularity of both branch zero sequence over-current protections and the issues involved in setting calculation. It points out that the setting calculation not only needs to comply with the relative regulations and standardized methods, but also should combine with the status quo and the primary connecting mode to conduct profound research such as the analysis of special situation after branch switch breakdown. In the process