金山店铁矿东区放顶工程优化设计及相关采矿技术的研究-采矿工程专业论文.docxVIP

武汉科技大学硕士学位论文 武汉科技大学硕士学位论文 第1页 摘 要 本文以武钢金山店铁矿东区为研究对象，研究金山J占铁矿东区一270米水平放顶工程优 化设计及相关的采矿技术。 本文利用地质调查得到的相关资料并采用巷道围岩变形破坏理论，在金山店铁矿东区 一270米水平进行放项。本次放顶采用无底柱分段崩落法崩落扇形中深孔爆破的落矿方式， 以放顶工程设计原则为准则，确定了放顶高度为15m和放顶范围，以及相关中深孔爆破参 数，并把进路间距由11．5m渊整剑15m，降低生产成本。 本文最后对金山店铁矿东区放顶及=¨：采过程中地爪进行了数值模拟，并对会山店铁矿 东区放顶过程中地压重新分布的规律进行分析，为矿山【E确地决定同采顺序和对地压进行 预测、管理提供了理论依据。本研究计算结果符合现场实际，分析结果为矿山安全生产提 供了理论基础。 关键词：无底柱分段崩落法；进路间距；地压；数值模拟 第1I页 第1I页 武汉科技大学硕士学位论文 Abstract Taking the worked．out area at east part of Jinshandian Iron Mine of Mine Company of Wuhan Steal an Iron Group as a case investigats，this paper studies the problem of underground stress on top during top-collapse engineering and concemed technology of mining at the elevation一270m at east part of Jinshandian Iron Mine． Through geological investigation，this paper introduces deformation and failure of surrounding rock theories，and researches into underground stress on top during top-collapse engineering at the elevation一270m at east part of Jinshandian Iron Mine This engineering adopts the mean that caves the rock is Fan-Pattern Medium--10-·long hole blasting in Sub--level caving without sill pillar．On the condition of principle of caving-out body in the top rock，This engineering adopts 1 5m height of caving—out body in the top rock，scope caving—out body in the top rock，parameters ofMedium—tO—long hole and adjusts the access space from 11．5m to 15m in order to reduce cost ofproduction． At last，the paper underground pressure numerical simulation is done for Jinshandian Iron Mine during top—collapse engineering at east part of the Mine，and make all analysis of the underground stress redistributing at east part of Jinshandian Iron Mine during top—collapsing process，and then give the Mine theoretical basis to decide sequence of caving correctly and forecast and contr01 of underground stress The computed results are consistent with the 10cal fact situation；the analysis results give theory basis for safe production in mine． Keywords：Sub—level caving without