2-隧道烘干机风管技术要求.docVIP

TUNNEL DRYER – DUCTING SPECIFICATION 隧道烘干机-风管技术说明 1/GENERALITY 概述 Supply and installation of ventilation ducting for Spooner Tunnel dryer. Spooner公司隧道烘干机的风管的供货和安装。 The tunnel dryer is composed of 3 main parts: 隧道烘干机主要由3段构成： 1 inclined part with 3 modules 1个倾斜段，由3个单体构成 1 top part with 5 modules 1个上段，由5个单体构成 1 bottom part with 5 modules 1个下段，由5个单体构成 General scope of supply: 供货范围概况： Supply and installation of all ducting for each part including elbows with turning vanes and support as per Spooner guide drawings 按照Spooner公司条件图的要求，供货并安装烘干机各段的所有风管，包括弯头、导流板和支撑； Installation and supply of all flanges and bolts 供货并安装所有的法兰和螺栓； Installation of dampers and accessories supplied by Spooner 安装Spooner公司供应的风门和配件； Supply and installation of structure support for wash down ducts, catch basins and heat exchangers 供货并安装缓清洗管、集水池，并供货并安装热交换机的支撑结构； Installation of heat exchangers supplied by Spooner 安装Spooner公司供货的热交换机； Supply and installation of exhaust chimney 供货并安装排气烟囱； Supply and installation of insulation made of rock wool 75 mm thick thermal coefficient RW3 and aluminum sheet protection 0.6mm thk, installed with screws and with sealing in junction lap 供货并安装75mm厚的岩棉保温层，保温系数RW3，外带0.6mm厚的铝板保护层，使用螺丝安装，接搭处进行密封； Painting of all part in carbon steel epoxy primer and finishing RAL blue 5000 所有碳钢部件喷涂环氧底漆和面漆，劳尔色卡蓝色5000（RAL blue 5000）； Supply of all sealing between flanges, dumpers and equipment. Sealing rope high temperature (200°C) dia 6mm compressed to 2mm after installation 供应法兰、风门和设备之间的所有密封材料。密封绳耐高温（200°C），直径6mm，安装后压缩到2mm。 2/ PART 1 - INCLINED PART (exchanger, fresh air fan , exhaust fan and module 3 recirculation fan at +10.00m; recirculation fans for zones 1 2 installed at + 5.00m) 第1段—斜坡段（热交换机、净气风扇、排气扇和位于+10.00m处的第3单体循环风机；位于+5.00m处的第1、2单体循环风机） The part 1 is composed of 第1段由以下部分构成： a/ equipment supplied and installed by Spooner Spooner公司供货并已安装的设备 3 dryer modules 3个烘干机单体 1 fresh air fan including filter 1个净气风扇，带过滤器 3 exhaust fans 3个排气扇 3 recirculation fans 3个循环风机 b/ equipment