德尔格 Evita 4 呼吸机临床实用培训讲义（医院版） ..pptVIP

呼吸机管路部件的消毒 通气软管、储水器及Y-型管 在高温消毒（93摄氏度/10分钟）或2%戊二醛浸泡消毒，清洗晾干 134摄氏度蒸汽消毒灭菌 不可用 含氯消毒剂 过氧化物类消毒剂 苯酚类消毒剂 强有机酸 Evita 4－冷却空气过滤网 每4个星期用温水清洗，晾干 每年更换 定期清洗空压泵过滤网 谢谢大家. * * * * * * volume constant modes IPPV, SIMV, MMV with or without Pmax für pressure limited ventilation (PLV) the start-mode can be configured. This configuration is protected by an access code ? user manual no Apnoea Ventilation in IPPV and MMV modes can be preselected in the --configuration menu only those knobs and buttons which are available in this mode are shown position of a parameter is the same in all screens basic settings: define the ventilation pattern additional settings: parameter that need less attention Three steps to change ventilation mode: 1 touch the mode button  ? colour changes to yellow, preview page 2 check and adjust/preadjust settings - active parameters: LED - yellow - additional parameters: LED - white 3 confirm the new mode = press rotary knob  ? colour changes to black with “LED on“ * * * When he a patient is under Controlled Mechanical Ventilation, sometimes she will begin to make some small inspiratory efforts. Traditionally, this presents a problem. The ventilator is giving a positive pressure to the lungs, and the patient is creating with the expansion of her diaphragm or his/her chestspacewall a negative pressure in the lung. Thus we have two forces acting against each other which shouldnt be have this way. From one side the life support positive pressure of the ventilator and from the other side the small negative pressure efforts of the patient who wants to recover as soon as possible. * more comfortable for the patient less alarms, easier handling settings: Pinsp, PEEP, PASB,Tinsp, f, ramp Vtinsp high-monitoring Flowtrigger Apnoea Ventilation BIPAPAssist new with SW 4.0: allows assisted mandatory ventilation with pressure controlled strokes. Every recognised patient trigger is followed by a stroke * Curves and measured values only knobs and buttons which are