基于双向牵引技术的射频功放设计与仿真-硬件和射频工程师.PDF

28 6 Vol. 28 No. 6 2011 6 MICROELECTRONICS COMPU TER June 2011 高金辉, 李迎迎, 丛密芳 ( , 453007) : 射频功率放大器是无线通信系统的核心部件, 其输出功率和 加效率是设计的重点和难点, 现有方法很难 在功率和效率之间取得 一致. 为了解决这 一问题, 文中在综合考虑谐波分量以及负载阻抗源阻抗对输出功率和 加效率影响的基础上, 采用新型多谐波双向阻抗牵引技术, 结合实例设计了 一种高效率的射频功率放大器. 在ADS 中进行仿真, 仿真结果表明功放在获得最佳 加效率的同时又有较高输出功率, 证明了该方法的有效性. : 双向牵引; 多谐波; 功率 加效率; 输出功率 : T N722 : A : 1000- 7180( 2011) 06- 0118- 04 Design and Simulation Technology of Radio Frequency Power Amplifier Based on Biateral Pull GAO Jinhui, LI Yingying, CONG Mifang ( College of Physics and Information Engineering, H enan Normal U niversit y, Xinxiang 453007, China) Abstract: RF power amplifier is t he core component of w ireless communication system, its output power and added eff iciency are important and difficult to design. The consistent of output pow er and pow er added efficiency cant a chieved with existing methods. Considering the influence of harmonic, load and source impedance on output power and power added efficiency, by using multiharmonic bilat eral pull technology , design a high- efficiency RF power amplifier . Simulation results show that when the additional efficiency at best, t he out put pow er is also high, fully meet t he design requirements. Key words: bilateral pull; multi harmonic; pow er added efficiency; out put pow er [ 5, 6] , . 1 , , , , , , [ 1, 2] . . , [ 3] 2 . , 2. 1 [ 4] . , . . : . ( ) ( )