ACalculationMethodforFracturingFluidFriction一种压裂液管柱摩阻.PDF

Mine Engineering 矿山工程, 2018, 6(3), 175-182 Published Online July 2018 in Hans. /journal/me /10.12677/me.2018.63024 A Calculation Method for Fracturing Fluid Friction Jun Zhang CNPC Chuanqing Drilling Engineering Company Limited Changqing Downhole Technology Company, Xi’an Shaanxi th th th Received: Ju l. 4 , 2018; accepted: Ju l. 19 , 2018; published: Ju l. 26 , 2018 Abstract Because of the fracturing fluid friction, besides of the formation factors, the fracturing design and analysis of operation pressure and discharge rate have to consider the max pressure for the well- bore tubing and operation tubing, which causes lots of obstacles for the scientific and reasonable reservoir stimulation. At the same time, to ensure a success fracturing and reduce the wellbore failure in the stimulation operation, the fracturing liquid friction must be considered when calcu- late the operation pressure and increase the discharge rate. However, in the real situation, be- cause of the limited cost and operation time, friction for each fluid cannot be tested on site. At the same time, calculated friction by the empirical formula for the specific fluid will cause some error. Therefore, each fluid friction should be tested in lab, and then transform the lab results into loca- tion friction. The small ID tubing test friction results can guide the location operation well by ratio magnification, which also provide reference for the location operators to judge the real pressure in real time. It also provides a good way to reduce the calculation errors for the empirical formula, improve the fracturing design quality and useful analysis after fracturing. Keywords Fracturing Fluid Friction, Ant