10-羟基喜树碱乳酸-羟基乙酸共聚物超声微泡制备及工艺优化.docVIP

10-羟基喜树碱乳酸-羟基乙酸共聚物超声微泡制备及工艺优化 吴 青，朱照静（重庆医科大学药学院药剂学教研室，重庆 400016） 摘 要： 目的 探讨超声微泡的制备条件对粒径、包封率、表面形态等的影响，确定制备超声微泡的最佳工艺条件。 方法 以W/O/W型乳化溶剂挥发法制备微球，采用单因素实验和正交设计实验优化制备工艺。 结果 制备超声微泡的最佳条件是10-羟基喜树碱(10-hydroxy-camptothecin, HCPT) 25 mg，乳酸-羟基乙酸共聚物[poly(1actic-co-glycolic acid)，PLGA] 1.875 g，聚乙烯醇（PVA）浓度2%，内、外水相体积比为1∶5；此条件所制备超声微泡呈规则球形，表面光滑，电荷以-40～0 mv为主，粒径500～1 000 nm，包封率为80.99%，载药量为0.697 2%，体外超声成像清楚。 结论 优化制备条件，可制备出符合注射要求的超声微泡。 关键词：10-羟基喜树碱；乳酸-羟基乙酸共聚物；超声微泡；制备；优化 中图法分类号： 文献标识码：A Preparation and Technicalprocess Ooptimization of Preparation of HCPT-loaded PLGA Mmicrovesicles by Uultrasound WU Qing, ，ZHU Zhao-jing（ (Department of HYPERLINK javascript:showjdsw(jd_t,j_) Pharmaceutics, School of Pharmacy, Chongqing Medical University of Medical Sciences, Chongqing 400016，, China）) Abstract ：: Objective To discussinvestigate the effects of different technical conditions on the microvesicles size , envelopment rate, morphology of surface and so on in order to chooseselect the best technical conditions to prepare HCPT(10-hydroxy-camptothecin)-loaded PLGA microvesicles for injection guided by ultrasound．Methods Microvesicles were prepared by a water/oil/water emulsion and solvent evaporation method．Various factors related withto the envelopment rate and micmparticle size were studied, such as the ratio of water phase and oil phase, ultrasound power, and time, stirring time and so on．. Single facter The perpendicular experiments and HYPERLINK orthogonal design testingal design was chosencarried out to optimize the technology of microvesicles preparation．Results The best processing conditions for preparing microvesicles preparation were as following：: HCPT 25 mg, PLGA 1.875 g, the PVA concentration was2%, and the ratio of intemal and external phases was 1:5. These preparative variables can prepareproduced global, smooth and glossy microvesicles. Electric charges were probably between －40- to 0 mVv, microvesicles sizes were probablyranged from bet