消应力热处理(00001).docVIP

上海森松压力容器有限公司 Shanghai Morimatsu Pressure Vessel Co., Ltd. 热处理工艺卡 Heat Treatment Procedure Card 表9B-1(P1/1) 记录编号: SME13-5-20025 Form No.9B-1 Record No. Rev.1 工作令号 Job No. SME13-5-20025 产品名称 Item Name 12M3反应釜 工件名称/图号 Part Name/DWG.No. 下设备法兰/件号5 No.5 零件重量 Weight 727KG 数 量 Quantity 1件 工件草图 Sketch 材料牌号 Mat’l Spec. SA-105 最大名义厚度 Max. Nominal Thk 79+6 mm 热处理类型 Type of HT 堆焊后消应力 Stress Releasing 技术要求 Technical Requirements 检验方法 Inspection Method 硬度 Hardness ---- ---- 机械性能 Mechanical Property ---- ---- 工序号 No. 工序 Process 设备 Equipment 装炉方式及工装编号 Charging Manner Tech. Facilities No. 热电偶位置 Thermocouple Position 工艺曲线 Procedure Curve: T/℃ 620±15℃ 55~70℃/Hr 保温30 minutes 55~90℃/Hr Holding 30 minutes ≤400℃进炉Loading ≤400 Cooling in air t/min 1 升温 heating 油炉或 天燃气炉或电炉 Oil furnace or Natural Gas furnace or Electric furnace 见示图 See the sketch 热电偶2件，测工件温度，且必须直接接在工件上 Two thermocouples which gets to the workpiece directly to measure temp. 2 保温 Holding 3 降温 cooling 备注 Remarks: 1.每个工件接2件热电偶,按示意图布置; There are two thermocouples shall be laid on workpiece according to the sketch; 2.热处理的温度必须连续自动记录; The temperature of HT shall be recorded continuously and automatically; 3.热处理炉应有阻火墙,以防止喷火头直接喷射工件;There shall be firewall to protect workpiece from being ejected; 4.升温及降温时各部分温差不得大于120℃，保温期间温差不得大于30℃ The temperature difference while heating and cooling should be less than or equal to 120℃ and while holding s to 30℃; 5.进炉前，不锈钢表面除油污处理。 编制 Prep. By 焊接校对 Chkd. By 冷作会签 Chkd. By 审核 Rev. By 授权检验师 AI 上海森松压力容器有限公司 Shanghai Morimatsu Pressure Vessel Co., Ltd. 热处理工艺卡 Heat Treatment Procedure Card 表9B-1(P1/1) 记录编号: SME13-5-20025 Form No.9B-