JJG 275-2003多刃刀具角度规.pdf

trtr看 中华人民共和国国家计量检定规程 JJG275-2003 多刃 刀具 角 度 规 TheProtractorsforMultiplePointTool 2003一03一05发布 2003一09一01实施 国家 质 量 监 督 检 验 检 疫 总 局 发布 JJG 275-2003 尹o.o.o.o.o.o.o.o.o.o.o.o.0.0.、 。 ， 。 。 。 。 多刃刀具角度规检定规程 ; JJG 275-2003 Verification Regulation of the :代替JJG 275-1981沪 . Protractors for Multiple Point Tool 本规程经国家质量监督检验检疫总局于2003年03月05日批准，并自 2003年09月01日起施行。 归 口 单 位:全国几何量角度计量技术委员会 主要起草单位:中国一拖集团有限公司 参加起草单位:第一拖拉机股份有限公司 本规程委托全国几何量角度计量技术委员会负责解释 标准分享网 免费下载 刀 G 275- 2003 本规程主要起草人: 林 敏 (中国一拖集团有限公司) 靳丽霞 (中国一拖集团有限公司) 参加起草人 : 顾坤 明 (第一拖拉机股份有限公司) JJG 275-2003 目 录 1范围 ··························································································……(1) -2引用文献 ····················································································……(1) 3概述 ·······················································································..·……(1) 4计量性能要求··············································································……(2) 4.1各直尺工作面的直线度 ·······························································……(2) 4.2前角直尺工作面与后角直尺工作面、支承直尺工作面的垂直度 ············……(2) 4.3后角直尺与支承直尺的相对位移 。··················································…… (2) 4.4前角直尺与后角直尺的交点相对支承直尺的偏移 ······························……(2) 4.5示值误差 · (2) 5通用技术要求··························