cancsaz24520m92钢管外熔结环氧涂层.docVIP

CAN/CSA Z245.20-98 External Fusion Bond Epoxy Coating for Steel Pipe CAN/CSA Z245.21-98 External Polyethylene Coating for Pipe  Technical Editor: Solomon Ko Managing Editor: Gary Burford Senior Project Editor: Ann Martin Editor: Maria Adragna Publishing System Coordinators: Ursula Das/Grace Da Silva/Tarsem Suri ? Canadian Standards Association—1998 All rights reserved. No prêt of this publication may be reproduced in any form whatsoever without the prior permission of the publisher.  Contents Technical Committee on Oil and Gas Industry Pipeline Systems viii Subcommittee on Materials xii Task Force on Coated Pipe xiv Preface xvi Z245.20 External Fusion Bond Epoxy Coating For Steel Pipe Scope 3 Reference Publications 3 Definitions 4 General Requirements 4 Product Ordering Requirements 4 Standard Requirements 4 Optional Requirements 5 Rounding Procedure 5 Quality Program 5 Compliance 5 Materials 5 Pipe 5 Epoxy Powder 5 General 5 P0roperties 6 Packaging 6 Coating Application 6 Coating Qualification 6 General 6 Preparation of Laboratory-Coated Test Specimens 6 Coating Qualification Test Requirements 7 Production Application Practices and Equipment 7 General 7 Surface Preparation 7 Application and Curing Temperatures 7 Coating Thickness 7 End Finish 8 Production, Inspection, and Testing 8 Inspection Notice 8 Plant Access 8 Production Tests 8 Epoxy Powder and Coating 8 In-Line Inspection and Measurement 9 Production Test Rings 10 Repair of Coated Pipe 11 General 11 Patching 11 Stripping and Recoating 12 Markings 12 General 12 Required Markings 12 Handling and Storage 12 Handling 12 Storage 13 Test Reports and Certificates of Compliance 13 Test Procedures 13 Cure Time of the Epoxy Powder 13 Equipment 13 Procedure 14 Report 14 Gel Time of the Epoxy Powder 15 Equipment 16 Procedure 15 Report 15 Moisture Content of the Epoxy Powder—Titration 16 Equipment 16 Reagents 16 Procedure 16 Report 16 Moisture Content of the Epoxy Powder—Mass loss 16