多绳摩擦式矿井提升机研究与设计开发.docVIP

PAGE \* MERGEFORMAT PAGE \* MERGEFORMAT i 摘要  本文对多绳磨擦式矿井提升机发展及应用、种类及结构进行了综合阐述，对多绳摩擦式矿井提升的优缺点进行了分类和研究；论证了多绳摩擦提升的工作原理；介绍了多绳摩擦式矿井提升机的各种型号；在制动工作原理进行说明的基础上，对制动器进行了选型。结合特定的矿井的采煤及地质情况，对多绳摩擦式矿井提升机进行设备选型，形成一整套完备的矿井提升系统，整个系统的电控系统非常重要，所以最后对所设计的系统进行了电控系统设计。 多绳摩擦式矿井提升机系统的各系统的型号选型计算，及对各系统的统一布置，确定各系统的工作位置和尺寸，这些对多绳摩擦式矿井提升机在实际应用中提供了必要参数。 关键词：多绳摩擦式矿井提升机；选型；制动；系统 Abstract  In this paper, rope and more friction-mine hoist the development and application, type and structure of a comprehensive elaboration of multi-rope friction-mine the advantages and disadvantages of upgrading the classification and study of multi-rope friction demonstration enhance the work of principle; introduced a multi - - Rope friction-mine hoist the various models in principle that brake work on the basis of a selection of the brake. With a specific mine coal mining and geological conditions, the multi-rope friction-mine hoist a selection of equipment, a set of comprehensive mine hoist system, the whole system of electronic control is very important, so the final design of the system The control design. Multi-rope friction-mine hoist system of the Selection System Model, and the layout of the unified system, the system determine the location and size of these multi-rope friction-mine hoist in practical application to provide the necessary Parameters. Keywords: multi-rope friction-mine hoist; Selection; braking; system 目 录 TOC \o 1-3 \h \u HYPERLINK \l _Toc30849 摘要 PAGEREF _Toc30849 i HYPERLINK \l _Toc2812 Abstract PAGEREF _Toc2812 ii HYPERLINK \l _Toc22908 前言 PAGEREF _Toc22908 v HYPERLINK \l _Toc25301 1 提升机的概述 PAGEREF _Toc25301 1 HYPERLINK \l _Toc5165 1.1提升机的简介 PAGEREF _Toc5165 1 HYPERLINK \l _Toc21553 1.2提升机的用途和发展概况 PAGEREF _Toc21553 2 HYPERLINK \l _Toc9072 1.3提升机的工作原理 PAGEREF _Toc9072 4 HYPERLINK \l _Toc9599 2 提升机的组成 PAGEREF _Toc9599 6 HYPERLINK \l _Toc14042 2.1 工作机构 PAGEREF _Toc14042 6 HYPERLINK \l _Toc18270 2.2 制动系统 PAGEREF _Toc18270 7 HYPERLINK \l _Toc26244