使用维护说明书.docVIP

PAGE FT10 Escalator Use and maintenance handbook PAGE PAGE 1 一、一般介绍Introduction 1.1 FT10自动扶梯的性能：Performance of FT10 series of escalators： 自动扶梯是由两台带式输送机和一台链式输送机组成，带指扶手带系统、链指梯路系统。 FT10扶梯是我公司最新的自动扶梯产品，采用两条特殊的滚子链传动，符合EN115及国家标准GB16899-1997《自动扶梯与自动人行道的制造与安装安全规范》。它具有结构紧凑、外形美观、运行平稳、噪音低、维修方便等特点。广泛应用于商场、宾馆、写字楼等场所。 An escalator is consisted of two belt conveyors and a chain conveyor. The belt conveyor is designed to drive the handrail system, at the same time the chain conveyors are designed to drive the steps. FT10 series of escalators are the newest products of our company, which comply with the EN115 rule and National Standard GB16899-1997”, Safety rules for the construction and installation of escalators and passenger conveyors”. Not only the escalators have compact structures and beautiful outlines, but also they run smoothly with low noise and can be maintained easily. They are widely used on a lot of locations such as department stores, hotels, office buildings and etc. 1.2 FT10自动扶梯主要参数：Main Parameters： 型 号Model FT10 梯级宽度Nominal width of step B 1000mm 800mm 600mm 输送能力Capacity Q 9000persons/h 6750persons/h 4500persons/h 提升高度Rise of an escalator H ≤6m 倾斜角度Angle of inclination α 30° 35° 速 　 度Nominal speed V 0.5m/s 1.3 FT10自动扶梯的主要结构：Main parts： 　　　　　　　　　Superstructure of an escalator 1.Controller 2.Motor 3.Main shaft 4.Parts of holding belt 5.Friction wheel 6.Step 7.Step chain 8.Handrail 　　　　　　　　Lower structure of an escalator 1.Balustrade 2.Interior profile and balustrade decking 3.Skirting 4.Guide rails 5.Front tread 6.Combs 1.3.1驱动系统Driving system FT10自动扶梯的驱动系统位于自动扶梯的上部机房内。驱动机构主要由电机，减速机和制动器组成，减速机是精密蜗轮减速机，采用特殊的尼曼齿形和先进的加工工艺，具有结构紧凑、承载力大、工作平稳和噪音小等优点，电机轴通过弹性联轴器与减速机相连，这对装配和维修带来方便，电机功率按提升高度，斜度和梯级宽度进行配置。 The driving system of an escalator, which is consisted of a motor, a reducer and an operational brake, is located at the driving station. The reducer is a nice worm gear reducer adopting the spec