基于Multisim的调频通信系统仿真毕业设计.docx

PAGE \* MERGEFORMAT 61 LANZHOU UNIVERSITY OF TECHNOLOGY 题目 基于Multisim的调频通信系统仿真 学生姓名 学 号 专业班级 通信工程一班 指导教师 学 院 计算机与通信学院 答辩日期 基于Multisim的调频通信系统仿真 Simulation of frequency modulation communication system based on Multisim 摘要 高频电子线路系统地介绍了通信系统，特别是无线通信系统中的最基本电路及他们的功能，给出了定性及定量分析这些电路性能的方法。这些电路包括了发射系统和接收系统中的变容二极管直接调频、射极跟随器，放大器、高频小信号放大器、本振电路、混频电路、功放电路、鉴频器、低频放大器。利用Multisim仿真软件将各个电路进行仿真，最后，把各个电路进行级联，并进行修改，修改之后，逐级进行调试仿真，得出最终仿真结果图。　　本毕业设计的基本目的是：通过理论和实践学习，使我们了各个电路工作于高频时的工作原理，特性参数及微变等效电路，掌握高频单元电路的线路组成、基本工作原理、分析方法、技术要求及一些典型集成电路的实际应用，并且具备一定的理论水平和足够的实践技能，为进一步学习通讯技术的专业知识和职业技能打下基础。 关键词： 调频；发射系统；接收系统；Multisim 仿真；电路分析 ABSTRACT High Frequency Circuit systematic introduction to communication systems, particularly wireless communication systems and their basic function of the circuit, given the qualitative and quantitative analysis of these methods of circuit performance. The circuit includes a emission system and receiving system in Varactor diode direct FM,emitter follower, amplifier, High frequency small signal amplifier, The oscillator circuit , HYPERLINK /s?wd=mixer%20circuit \t _blank mixer circuit, The power amplifier circuit, frequency detector and HYPERLINK /s?wd=low-frequency%20amplifier%20 \t _blank low-frequency amplifier . Each circuit is simulated with Multisim simulation software, Finally, all the circuits are cascaded, And modify, After the modification, Step debugging simulation, The final simulation results figure. The basic design of this HYPERLINK /s?wd=finish%20school \t _blank finish school are: the theory and practice through teaching, so we know when each circuit at high working principle, characteristics and micro-dependent equivalent circuit parameters, frequency control circuit of the line unit composition, the basic working principle meth