毕业设计贵州六盘高速公路吴家寨隧道右线六盘端初步设计.docVIP

贵州六盘高速公路吴家寨隧道右线六盘端初步设计 贵州六盘高速公路吴家寨隧道右线六盘端初步设计 摘要 贵州省六盘水至盘县高速公路吴家寨隧道为分离式短隧道，其右线长268m，所在地段区域稳定性总体较好，但六盘端工程地质条件复杂。 根据该工程地质情况与分离式短隧道的特点，本设计以净空设计、洞门设计、衬砌设计、路面、防排水设计、通风照明消防及供配电、监控量测、施工方法、辅助施工、施工组织等为设计内容。本隧道采用复合式衬砌结构，利用直刚法，根据隧道埋深与地质的情况，对隧道二次衬砌的受力与变形进行验算，并得出验算结果。 关键词：高速公路隧道；洞门设计；衬砌验算 贵州六盘高速公路吴家寨隧道右线六盘端初步设计 THE preliminary design FOR THE LIUPAN END OF THE WUJIAZHAI tunnel right line OF G Abstract Wujiazhai tunnel belong to the highway in Guizhou Province from Liupanshui to Panxian is a short separated tunnel, the length of the right line is 268m, and the regional stability of the most site is good，but the engineering geological conditions of the end of Liupan are complex. According to the engineering geological conditions and the features of separation short tunnels, this design include clearance space design, portal design, lining design, road surface, drainage design, ventilation, lighting, fire control, power supply, measurement, construction method, auxiliary construction, construction organization. the tunnel lining use composite structure, and using direct stiffness method, according to tunnel depth and the geological situation，check the force and deformation of tunnel secondary lining, and obtain the checked results. Key words: highway tunnel; portal design; lining checked  目 录 TOC \o 1-3 \h \z \u HYPERLINK \l _Toc231994355 第1章 绪论 PAGEREF _Toc231994355 \h 1 HYPERLINK \l _Toc231994356 1.1 课题背景及目的 PAGEREF _Toc231994356 \h 1 HYPERLINK \l _Toc231994357 1.2 国内外研究状况 PAGEREF _Toc231994357 \h 1 HYPERLINK \l _Toc231994358 1.3 课题研究方法 PAGEREF _Toc231994358 \h 1 HYPERLINK \l _Toc231994359 1.4 设计构成及研究内容 PAGEREF _Toc231994359 \h 2 HYPERLINK \l _Toc231994360 第2章 工程概况 PAGEREF _Toc231994360 \h 3 HYPERLINK \l _Toc231994361 2.1 概述 PAGEREF _Toc231994361 \h 3 HYPERLINK \l _Toc231994362 2.2 工程地质条件 PAGEREF _Toc231994362 \h 3 HYPERLINK \l _Toc231994363 2.2.1 地形地貌 PAGEREF _Toc231994363 \h 3 HYPERLINK \l _Toc231994364 2.