定稿基于UCC的开关电源设计.docVIP

基于UCC28019的开关电源设计 Design of Switching Power Supply Based on UCC28019 专 业：电子信息工程 学 号姓 名：段 闪 指导老师：胡 晗 基于UCC28019的开关电源设计 摘要：电气设备的功率因数过低，会加重电网的负载，造成电网容量的浪费。功率因数的优劣是开关电源性能好坏的一个重要评价指标。为了便于研制和生产有源功率因数校正器，现在功率因数校正PFC（Power Factor Correction）的控制电路已集成化，有多种PFC集成控制电路芯片可供选择。本文采用TI公司生产的功率因数校正芯片UCC28019设计出一种高功率因数、高效率、低谐波的单相整流PFC开关电源。用两片高速串行AD转换器ADS7818对输出电压和电流采样,采样数据送单片机STC89C52处理并由液晶显示器SN1602实时显示当前输出电压、电流。系统具有2.5A过流保护。测试结果表明功率因数大于0.95，效率达到92%，输入电流波形谐波失真小于5%。 关键词：开关电源 ；STC89C52；功率因数校正；UCC28019； 过流保护 Design of Switching Power Supply Based on UCC28019 Abstract: The power factor of the electrical equipment is too low, which will increase the load of the power grid and result in wasting of power grid capacity. Theadvantage or disadvantage of the power factors is an important evaluation indicator for switching power supply performance. In order to develop and produce theActive Power Factor Correction, the control circuit of PFC (Power Factor Correction) has been integrated now, so there are a variety of integrated PFC control circuit chips to choose from. In this paper, UCC28019 PFC chip which is produced by TI Company is used to design a kind of Single-phase PFC rectifier switching power supply with a high power factor, high efficiency, low harmonic. With two high-speed serial AD converter ADS7818 of output voltage and current sampling, sample processing data is sent to the STC89C52 single-chip and LCD SN1602 real-time displays the current output voltage and current. The system has 2.5A overcurrent protection. The test results show that the power factor ismuch greater than 0.95, the efficiency reaches to 92%,Harmonic distortion of input current waveform is less than 5%. Keywords: switching power supply。 STC89C52。 power factor correction。 UCC28019。 over-current protection1绪论1 1.1 引言1 1.2 开关电源的发展历史1 1.3 开关电源的基本结构2 1.4谐波电流对电网的危害3 2开关电源的功率因数4 2.1 功率因数的定义4 2.2 功率因数校正技术4 2.2.1 功率因数校正的由来4 2.2.2 功率因数校正的基本原理6 3 基于UCC28019的开关电源设计及主要元器件参数计算7 3.1系统方案设计与论证7 3.1.1 EMI滤波模块