矿泉水瓶热流道注射模具设计.doc

矿泉水瓶坯热流道注射模具的设计 PAGE 27 - 成都理工大学工程技术学院毕业论文 矿泉水瓶坯热流道 注射模具的设计 姓名：XXX 专业：XXX 指导老师：XXX 摘要 这篇论文是对大批量生产的饮料瓶坯进行了热流道注射模具的设计，瓶坯材料为PETP，其熔点较高（260℃ 关键词：热流道 优化设计 PET瓶坯 侧向分型 Abstract This paper deals with the injection mould with hot runner to inject PET bottles, which leads to higher productivity. The material of bottles is PETP which with a higher melting point, about 260℃ around, so it has a narrow range of mounding temperature .If we adopt ordinary mounding System to produce bottles which have more moulds in a cavity The fluidity of the melting material of PET will greatly decline; indeed freeze, so we adopt injection mould with hot runner to complete the production. The design to the diameter of hot runner and hot gate was consult a paper from Su Juanhua. It deals with the optimal diameter design in injection mould. The computational results of the optimal programming are found to be in good agreement with the experiential data. The work performed in this paper will make a contribution to the application of the hot runner in injection mould. The mould adopts two oblique pillars to detach the mould based the characteristic of the bottles. Key words: hot runners, Optimization, PET bottles, lateral detach the mould 目录 摘要?????????????????????????????????????????????????????????????????????????????????????????????????????I Abstract?????????????????????????????????????????????????????????????????????????????????????????????II 前言???????????????????????????????????????????????????????????????????????????????????????????????????????1 2 塑件的工艺分析，模具结构方案的确定、设备的校核??????????????????2 2.1塑料工艺分析、填写工艺卡????????????????????????????????????????????2 2.2确定模具方案????????????????????????????????????????????????????????????????????5 2.3注射机的选择和校核????????????????????????????????????????????????????????7 3 浇注系统的设计??????????????????????????????????????????????????????????????????????????????????10 3.1热流道板的设计????????????????????????????????????????????????????????????????10 3.2浇口套的设计?????????