基于matlabsimulink的模拟通信系统的仿真(线性调制文档.docVIP

陕西理工学院 通信原理课程设计 题 目 基于SIMULINK的通信系统仿真 学 号 1113024132 学生姓名 周龙刚 专业名称 通信工程 所在系(院) 物理与电信工程学院 指导教师 侯宝生 2014 年 2 月 24 日 题目 基于SIMULINK的模拟通信系统的仿真（线性调制） 摘要 在模拟通信系统中，由模拟信源产生的携带信息的消息经过传感器转换成电信号，模拟基带信号在经过调制将低通频谱搬移到载波频率上适应信道，最终解调还原成电信号；在数字传输系统中，数字信号对高频载波进行调制，变为频带信号，通过信道传输，在接收端解调后恢复成数字信号。本文应用了幅度调制以及键控法产生调制与解调信号。 本论文中主要通过对SIMULINK工具箱的学习和使用，利用其丰富的模板以及本科对通信原理知识的掌握，完成了AM、DSB、SSB、2ASK、2FSK、2PSK三种模拟信号和三种数字信号的调制与解调，以及用SIMULINK进行设计和仿真。首先我进行了两种通信系统的建模以及不同信号系统的原理研究，然后将学习总结出的相应理论与SIMULINK中丰富的模块相结合实现仿真系统的建模,并且调整参数直到仿真波形输出，观察效果，最终对设计结论进行总结。 关键词 通信系统 调制 SIMULINK? ?? Title Based on SIMULINK communications system simulation Abstract In simulation of communication system, produced by simulation source carry information news after sensor into electrical signal, analog baseband signal after a low pass spectrum will move to adapt to the carrier frequency channel, eventually demodulation reductive into electrical signals; In digital transmission system, digital signal to the high frequency modulated carrier, a band signal, through the channel transmission, at the receiving end after demodulation back into a digital signal. This paper applied the amplitude modulation and keying method produce modulation and demodulation signal. This paper mainly through Simulink tool box the study and use of the use of its rich templates and the undergraduate course communication principle of the knowledge, and completed the AM, DSB, SSB, 2 ASK, 2 FSK, 2 PSK three simulation signal and three kinds of digital signal modulation and demodulation, and using Simulink for design and simulation. First I two kinds of communication system model and the principle of different signal system research, and then will study summarized the corresponding theory and Simulink rich module in combining the modeling of the simulation system is realized, and adjust the parameters of the simulation output waveform until,