变截面移动模架施工线形控制分析.pdfVIP

摘 要 移动模架施工法在我国研究已较为成熟，但主要是针对等截面连续梁桥，针对变截 面连续梁桥应用移动模架施工法的研究较少。 本文依托秀涂互通主线桥工程应用有限元软件Midas/Civil 建立移动模架模型，采用 先计算移动模架与变截面连续梁接触面柔度系数从而推导出刚度值的方法，计算出变截 面连续梁作用在移动模架上的荷载。该计算方法可为今后变截面移动模架的研究提供计 算思路。 在结果处理过程中文中采用了统计分析软件1stOpt，对混凝土浇筑工况下移动模架 的竖向位移进行数据分析，以研究移动模架纵向及横向线型变化规律。 近些年来，我国连续梁桥的计算方法多以有限元法为基础，如正装分析法，倒装分 析法，无应力状态计算法。本文以两跨连续梁为例，研究分别在节点荷载作用和非节点 荷载作用下的有限元分析基本思路，总结了有限元计算方法的基本步骤。 关键词：变截面连续梁桥；移动模架施工；荷载分布；线型变化；Midas I 万方数据 Abstract Movable scaffolding construction method in our study is more mature, but mainly for the Continuous Beam Bridge, for the application of uniform continuous beam bridge few studies movable formwork law. This paper relies on the show painted interoperability main bridge engineering finite element software Midas / Civil establish mobile mold model, using the method first calculates the moving mold continuous beam with variable cross-section contact surface softness to derive the stiffness coefficient values calculated continuous variable cross-section Liang role in moving mode load shelves. This calculation method can provide ideas for future research to calculate variable cross-section mobile formwork. In the result the process used in Chinese statistical analysis software 1stOpt, pouring concrete conditions of the vertical displacement of the movable formwork statistical analysis to study the vertical and horizontal movable formwork linear variation. Decades of continuous girder bridge is a bridge-building in the application of more bridge, its structure calculation method to use more formal wear analysis, stress analysis and flip-state calculation method, these t