微波低通滤波器的仿真设计毕业论文.doc

陕西理工学院毕业设计 微波低通滤波器的仿真设计 [摘要] 近年来，随着军事、通迅、科研的发展，市场对微波滤波器在机能方面的需要不断地升迁。在微波电路系统中，滤波器的性能对电路的性能指标有很大的影响，于是设计一个高性能的滤波器，对设计微波电路系统具有很重要的影响。本文设计了一个微带线微波低通滤波器.低通滤波器的原型为切比雪夫低通滤波器，输入输出阻抗为50，截止频率为4GHz，3阶，带内波纹为3dB. 首先依据理查德变换和科洛达规则对切比雪夫低通滤波器原型进行转换。然后在射频软件（ADS）中计算出微带线的尺寸并且进行建模仿真。最后对仿真结果进行调谐优化,仿真结果达到设计要求. [关键字] 微波低通滤波器 微带线 ADS Simulation design of microwave low-pass filter xxxx (Grade 10,Class 04,Major electronics and information engineering，School of Physics and Telecommunication Engineering.，Shaanxi University of Technology，Hanzhong Shaanxi，723003) Tutor: xxxxx Abstract: In recent years, with the development of military, communications, research, and market need for microwave filters constantly promoted in the function aspect. In microwave circuit system, the performance of filter circuit has great influence on the performance index of the circuit, so to design a high performance filter has a significant impact on the design of microwave circuit system. This paper describes the design of a microstrip line microwave low-pass filter. The low-pass filter prototype is the Chebyshev low-pass filter, input and output impedance is 50, and cut-off frequency is 4GHz, 3 bands, the band ripple is 3dB. Firstly according to Richard transformation and Kuroda rules on Chebyshev low-pass filter prototype conversion. Then calculate the size of microstrip line and simulation in the RF software (ADS). Finally, the simulation results are tuned to optimization, and the simulation results meets the design requirements. Keywords:Microwave low-pass filter line ADS 目录 TOC \o 1-3 \h \u HYPERLINK \l _Toc19185 1 绪论 1 HYPERLINK \l _Toc2954 1.1 课题的研究背景及意义 l _Toc16662 1.2 发展历程及国内外研究现状 l _Toc32156 1.3 ADS软件简介 l _Toc9977 2 微波低通滤波器的设计理论 l _Toc27332 2.1 滤波器的定义及分类 l _Toc2476 2.2滤波器的主要指数指标 l _Toc12356 2.3 切比雪夫低通滤波器设计理论 l _Toc11262 2.3.1 切比雪夫低通滤波器原理 l _Toc15869 3 微带传输线 l _Toc15724 3.1 传输线理论 l _Toc4110 3.2 微带传输线 l _Toc4551 3.3 微带线的设计方法 l _Toc6768 4 微带线低通滤波器的设计 l _Toc9962 4.1 由集总元件低通滤波器变换