质量流量计原理.pptVIP

投表准备工作 传感器、变送器接线检查及设备上电。 专用信号电缆 电源接线 输出接线 投表准备工作 仪表参数检查 传感器特性化参数、仪表系数等与设备铭牌、校准证书是否一致。 投表准备工作 仪表基本组态 组态测量单位，根据需要选择过程变量的单位，包括质量流量、体积流量、温度、密度等； 组态毫安输出或脉冲输出的过程变量与量程； 组态过程变量阻尼，包括流量，密度，温度； 组态流向； 回路测试（数据远传）； 仪表调零（并不总是需要）。 投表准备工作 仪表组态数据记录 记录全部仪表组态数据，尤其是记录每次调完零点后的零点偏置值（Zero offset)，便于仪表故障检查。 日常维护 定期记录各项过程变量数值，对比流量、密度、温度检查工艺过程是否稳定； 定期记录传感器测试点数据，检查传感器自身状态是否正常； 电源与信号电缆外观检查是否完好； 电缆穿管、接线腔内是否潮湿，密封圈完好，丝扣上涂脂，密封不用的进线口； 流量计的零点检查与周期标定。 常见问题？ 在没有输油时有流量显示？ 流量计与上位机数据不一致？ 流量计与油罐计量误差？ 是否需要过滤器与消气器？ 在没有输油时有流量显示？ 在没有输油时有流量显示？ 仪表问题 零点漂移 调零不正确 小流量设置过低 外界干扰 回路未调整（上位机有显示而仪表无显示） 工艺问题 阀门泄漏 介质含气，不满管 管线卸压导致的不满管 讨论 谢谢！ * Welcome Latest Developments Introductions * 12/13/96 4 Intro-1 (= Transparency 2) Note: TX-2 depicts a system based on the RFT9739. For the same system with the RFT9712, use TX-144; for the IFT9701, use TX-145. Use TX-2 to orient the class: Point out corresponding components on the PMDs. Don’t spend a lot of time at this point explaining what particular components do or how to operate them. Also, don’t confuse things at this point by using model designations. Make sure class understands the distinction between the transmitter interface (used to communicate with the transmitter but generally not required for normal operation) and the peripheral interface (which is usually the operating interface with the flowmeter). * 12/13/96 4 Intro-1 (= Transparency 2) Note: TX-2 depicts a system based on the RFT9739. For the same system with the RFT9712, use TX-144; for the IFT9701, use TX-145. Use TX-2 to orient the class: Point out corresponding components on the PMDs. Don’t spend a lot of time at this point explaining what particular components do or how to operate them. Also, don’t confuse things at this point by using model designations. Make sure class understands the distinction between the transmitter interface (used to communicate with the transmitter but generally not required for normal operation) and the peripheral interface (which is usually the operating interface with t