无线抢答器英文资料.docVIP

Wireless Transceiver Modules Introduction Radio transmitter devices are working in the radio frequency, so the requirements of the device is higher, the general time it is very difficult to complete under the conditions of production and testing work, and at present the application of radio technology for more and more widely, especially for radio enthusiasts to a number of business that, in order to have all the high-frequency testing equipment is almost unrealistic, because the equipment is very expensive. In response to these actual circumstances, with many professional manufacturer specializing in wireless data transmission for the wireless transceiver modules, will be high-frequency part of the work of installation and commissioning of all production sites in the professional completed, the user just to provide power and to be sent encoded data, the receiver can output data to be sent end of the original data, it can be the application of radio technology to promote. From the current radio transceiver module of the application point of view, can be divided into two categories: AM and FM transceiver module and transceiver modules。 In the wireless radio, television, communications, remote control, telemetry and other devices or systems, in addition to the use of amplitude modulation (AM), but also widely used in frequency modulation ( FM). The following two main properties of modulation compared： Anti-interference capacity The main advantage of FM is its strong anti-interference performance. The so-called anti-interference, and mainly refers to the input signal-noise ratio (SNR referred to as S / N) under the same conditions, the FM receiver output signal to noise ratio large AM receiver in the output signal to noise ratio. FM than AM and strong anti-interference system can be two reasons for the launch signal power system size for analysis. FM wave edge of the power frequency component is separated from the carrier out of power. MFM modulation coefficient t