临潼污水处理厂二期工程工艺设计研究-建筑与土木工程专业论文.docxVIP

II II 摘要 摘 要 PAGE IV PAGE IV 本文以临潼污水处理厂二期工程工艺设计为研究对象，通过对污水处理厂一 期工程实际运行水质、水量、主要处理设备和污染物处理效果等统计与实际监测 分析，确定了二期工程设计规模和水质指标，对比选择推荐的工艺方案进行了参 数选取和主要水处理构筑物工艺设计计算、工程投资估算和处理成本分析。得到 主要结果如下： （1）通过对临潼污水处理厂实际运行水量统计和取样监测分析，结合污水 厂服务区的发展与排水管网建设情况，运用累计频率分析的方法，确定二期工程 设计规模为 2.5×104m3/d； （2）统计分析污水厂一期工程实际运行的水质数据，结合现场采样检测数 据，取定保证率为 90%，进水水质确定为 BOD5：150mg/L，COD：300 mg/L， SS：150 mg/L，NH3-N：30 mg/L，TN：40 mg/L，TP：4.5mg/L。 （3）通过工艺比选，确定污水厂二期工程采用厌氧-缺氧-好氧活性污泥法 工艺。二期的污泥处理与一期分开新建，确定采用浓缩—消化—脱水—干化—集 中外运的处理工艺流程。 （4）二期工程采用(3)中的污水和污泥处理工艺，水价最后确定为为 1.4 元 每吨。污水厂二期扩建工程的建成投产，将使每年排入渭河的污染负荷大幅度削 减，有较好的环境和社会效益。 关键词：污水水质，厌氧-缺氧-好氧活性污泥法工艺，工艺设计研究 A Abstract The object of the research of this article is the process design of the second phase of the Lintong Wastewater Treatment Plant.Analysing the statistics of the quality and the quantity of the sewage, then determines the requirement on water quality and quantity for the second phase of the sewage sludge treatment process.After optimize and compare of the main structures, discuss and analyse the investment of this project.Below are the results got in this study: By monitoring the quantity and quality of the sewage at the entrance of the treatment,as the city is developing fast these years, the second phase of the treatment plant is determined to be designed with 2.5×104m3/d； After analyzing the statistics of the plant offered and the data Monitored at the entrance,90 percentages is suggested for the design of the second phase of the Lintong Wastewater Treatment Plant, determining the quality of the sewage as BOD5 : 150mg/L,COD:300mg/L,SS:150mg/L,NH3-N:30mg/L,TN :40mg/L,TP:4.5mg/L； Anaerobic-Anoxic-Oxic Activated Sludge Process is suggested to be used in the plant,after comparing with other methods, by analyzing the the quality and quantity of the sewage and budget for the project. The second phase sludge rebuilt and decides to use the process as thickening-digested-drying-transport； With the plant using the technology (3) to design the second phase, t