CATIA官方基本操作详细教程.docVIP

CATIA Basics Detailed Steps COPYRIGHT DASSAULT SYSTEMES 2002 PAGE 3 CATIA Training COPYRIGHT DASSAULT SYSTEMES 2002 Version 5 Release 9 June 2002 EDU-CAT-E-COM-FS-V5R9 CATIA Basics Detailed Steps Table of Contents TOC \h \z \t Heading 1,1,Heading 2,2 Manipulating Objects 3 Step 1: Start and Open a document 3 Step 2: Change the Part Number 4 Step 3: Change graphic properties 5 Step 4: Open a new Document 7 Step 5: Copy / Paste a PartBody 8 Step 6: Modify a feature 8 Step 7: Use the Compass 9 Step 8: Hide and delete a Body 11 Manipulating Objects In this exercise you will learn basic tools to manipulate documents and get familiar with standard CATIA V5 interface. Step 1: Start and Open a document Start Catia. Open CATCOMStep-dolt.CATPart and select mm as model unit by going to Tools + Options + General + Units. You must get: Step 2: Change the Part Number Save as the filename Select File / Save as. You can toggle Save as new document to specify a new internal identifier. Regenerating internal identifiers will avoid instantiation conflicts in Assembly Design. If you select Save as new document, you must close the CATCOMStep-Dolt.CATPart and open the new document Step2.CATPart. Change the part number. To change the part number, select on the Tree ‘Part Number’ and with MB3 choice Properties. You can click Alt +Enter to get the same following window: See the next image to verify the good result. Step 3: Change graphic properties Change color of 5 faces. First, display the Graphics Properties Toolbar. Keeping the Key Ctrl pressed, select 5 faces and change theirs color. Apply a material Select the appropriate icon . Choice Silver and then click on the top of the Tree (you can select the Part Body). To render on the workbench the material, go to View / Render/ Apply Customized View. and select Materials: You must get this appearance: You can select too this icon on the View Toolbar. Step 4: Open a new Document Open New Part Select