粉末冶金TiAl基合金高温变形行为及其本构模型-中国有色金属学报.PDF

20 1 2010 10 Vol.20 Special 1 The Chinese Journal of Nonferrous Metals Oct. 2010 1004-0609(2010)S1-s0269-05 TiAl ( 110016) Gleeble® 3800 Ti-47Al-2Cr-2Nb-0.2W-0.15B(%) −3 0 −1 50% Ti-47Al-2Cr-2Nb- 1 100~1 250 10 ~10 s 0.2W-0.15B , Arrhenius Zener-Hollomon Ti-47Al-2Cr-2Nb-0.2W-0.15B DEFORMTM 3D Ti-47Al-2Cr-2Nb-0.2W- 0.15B TiAl TF 804.3 A High temperature deformation behavior of powder metallurgy TiAl alloy and its constitutive model WANG Gang, XU Lei, CUI Yu-you, YANG Rui (Institute of Metal Research, Chinese Academy of Sciences, Shenyang 110016, China) Abstract: The high temperature deformation behavior of PM TiAl alloy Ti-47Al-2Cr-2Nb-0.2W-0.15B (mole fraction, %) was investigated by hot compression tests on Gleeble® 3800 machine at the temperature range of 1 100−1 250 , strain rates between 10−3 s−1 and 1 s−1 and deformation rate of 50% of the samples. The results show that the flow stress of the TiAl alloy increases quickly with increasing strain and then reaches a peak, then decreases to a steady value. The steady and peak stress significantly decreases with the increase of the deformation temperature and the decrease of the strain rate. The flow stress model of the TiAl alloy during high temperature deformation was established based on the Arrhenius equations and Zener-Hollomon parameter, the model was validated using the DEFORMTMTM 3D software. And the simulation results indicate that the flow stress constitutive mo