焊接坡口形式(英文版).docVIP

PAGE 3 Welding Grooves’ Forms and Types GXX-XXXXX Scope This document defines the code of welding groove, chamfering and different kinds of grooves. This document can be used for all structural welding joints. 2 Definitions of groove code 2.1 Butt joint 2.2 Fillet joint GXX-XXXXX 3 Chamfering If two base plates’ thickness are different, they should be constructed as Table 1. Table 1 Chamfering details Arrangement plan Note Section Plan a=t1-t Chamfering if a＞3mm； L=3a; —The direction of these grooves as I,1/2V,V,X, ，K ； Consider the thin plate, when automatic welding. 4 But