汽车内饰板冲压成形有限元模拟分析.PDFVIP

上半月出版 Casting Forging Welding 金属铸锻焊技术 汽车内饰板冲压成形有限元模拟分析 谢玲玲 黄贞益 郑光文 章小峰 渊安徽工业大学材料科学与工程学院金属材料重点实验室袁安徽马鞍山243002 冤 摘 要院根据钣金成形过程数值模拟技术袁 以某汽车内饰板为研究对象对其进行冲压过程仿真曰 阐述了用 Dynaform 软件实现板料成形数值模拟的基本步骤和一些关键技术袁如零件网格的完善尧工艺补充面修补和压延筋的设 计及布置等遥模拟结果表明袁相关工艺参数的合理设置袁可以改善出现的起皱和拉裂现象袁为模具设计优化提供参考依据遥 关键词院 内饰板曰有限元模拟曰Dynaform 软件曰钣金成形曰拉延筋 中图分类号院TG385.2 文献标识码院 文章编号院 Finite Element Simulation Analysis of Stamping Process for Automobile Interior-plaque XIE Lingling, HUANG Zhen yi, ZHENG Guangwen, ZHANG Xiaofeng (K ey Lab of Materials and Processing, School of Materials Science Engineering, A nhui Univers ity of Technology, Maanshan 243002, China) Abstract 院According to the numerical simulation technique for sheet forming process, the stamping process of some automobile interior-plaque was simulated; the basic numerical simulation step and some key techniques of sheet forming were discussed based on Dynaform software, such as the perfection of parts grid, the repair of process added surface and the design and distribution of draw-bead. The simulation results show the relevant technological parameters are set reasonably, which can improve the wrinkling and cracking problems of automobile covering panel, and may provide a reference for die designing. Key words 院interior-plaque; finite element simulation; Dynaform software; sheet forming; draw-bead 在钣金成形过程中袁 板料要经历很大的塑性变 本文以汽车内饰板为研究对象袁采用Dynaform 形袁是一个非常复杂的物理过程袁有许多因素会直接 软件实现板料成形有限元模拟袁 并逐步改善有限元 或间接地影响成形的结果遥 设计人员很难定量地了 建模技术袁最终得到比较理想的模拟结果遥 解和