A guide to use message service of GSM to realize remote control全英文指导说明.docVIP

A guide to use message service of GSM to realize remote control Introduction The GSM module V2.0 from DFRobot can be droved directly by Arduino, and it’s very easy to get started for newbie, so Its possible for everyone to control your robot or realize intelligent household by using the GSM module and Arduino or computer, and eventually allow you take over everything. Fig.1 GSM Module Fig.1 GSM Module The video shows a demo of using GSM module and Arduino to control remotely the LED connected to Arduino Uno. Of course, the program could also be very easily used to control the electrical appliance or other devices such as the curtain and camera, and thus realize so-called smart home. Once you have Arduino and GSM module, all it takes is only a good idea. In our demo, after the GSM module is all ready, you can control the pins 3 to 9 on the Arduino board to leave the pins at 0 V or to raise the pin to 5V by sending short message. The format of the commands is DFSTATENO, where DF is the flag to position the Command in the data received from Serial port, you could also change it to other string or character, STATE is the target pins level you want to set, the value could be H or L, and the NO gives the number of the pin you want to control. An example of this is DFH5, which tells the Arduino to output a high level on digital pin 5. In addition, the command is case-sensitive. You can easily change the format of commands in order to make it more humanistic and intuitive in our demo, or even you can write an application for your smartphone to enable better control. Hardware list Arduino Uno (SKU: DFR0109) GPS/GPRS/GSM Module V2.0 (SKU: TEL0051) Lithium Polymer Battery (7.4V, SKU: FIT0137) SIM card For more details please visit http://www.DFR Outlook In the fast paced world people need more leisure time and quality time, so the concept of intelligent household means the optimization of time, and provide a very convenient lifestyle, of co