配电网单相接地故障的仿真分析_王艳松.pdfVIP

DOI :10.13336/j.1003 -6520.hve.2008.01.017 34 1 　　　　 Vol.34 No.1 　　2008 　　1 High Voltage Engineering J an.　2008 ·123 · 王艳松, 解　飞 (中国石油大学信息与控制工程学院, 东营257062) 　:, Matlab Simulink , 、、 , 。 1 (0 ～ 0.02 s), , 。 、、, 。 :;;;;; :T M711 :A :1003-6520 (2008)01-0123-05 Simulation and Analysis of Single-phase to Ground Fault in Distribution Networks WANG Yan-song, XIE Fei (College of Information and Control Engineering, Universit of Petroleum China, Dong ing 257062, China) Abstract:The transient characteristic of single-phase to ground fault is used for the fault line selection and fault dis- tance detection in distribution netw ork.The distribution netw ork simulation model is established for the Neutral Un- effectual Grounded S stem (NUGS), based on the Simulink of Matlab.Various factors, such as different short cir- cuit time, arc-resistances, fault distances, line length and the compensation rates of arc-suppression coil, should be put into overall consideration.The single-phase to ground fault of the NUGS is simulated so as to research the tran- sient characteristics of single-phase to ground fault in dist ribution netw ork.Through anal zing these transient char- acteristics such as zero-sequence current and voltage, fault-phase voltage and current, it is concluded that these tran- sient characteristics change with the different short circuit time, arc-resistances, fault distances and the compensa- tion rates of arc-supperession coil, which provide a theor basis to stud the fault line selection and fault distance de- tection f or the single-phase to ground fault in distribution