轮机英语新教材电子版Lesson.doc

Unit 2 Auxiliary Machinery Lesson 13 Marine Boilers and Their Construction A boiler in one form or another will be found on every type of ship. Where the main machinery is steam powered, one or more large water -tube boilers will be fitted to produce steam at very high temperatures and pressures. On a diesel main machinery vessel, a smaller (usually fire tube type) boiler will be fitted to provide steam for the various ship services. Even within the two basic design types, water tube and fire tube. A variety of designs and variations exist. A boiler is used to heat feed water in order to produce steam. The energy released by the burning fuel in the boiler furnace is stored (as temperature and pressure) in the steam produced. All boilers have a furnace or combustion chamber where fuel is burnt to release its energy. Air is supplied to the boiler furnace to enable combustion of the fuel to take place. A large surface area between the combustion chamber and the water enables the energy of combustion, in the form of heat, to be transferred to the water. A drum must be provided where steam and water can separate. There must also be a variety of fittings and controls to ensure that fuel oil, air and feed water supplies are matched to the demand for steam. Finally there must be a number of fittings or mountings which ensure the safe operation of the boiler. In the steam generation process the feed water enters the boiler where it is heated and becomes steam. The feed water circulates from the steam drum to the water drum and is heated in the process. Some of the feed water passes through tubes surrounding the furnace, i.e. Water wall and floor tubes, where it is heated and returned to the steam drum. The steam is produced in a steam drum and may be drawn off for use from here. It is known as wet or saturated steam in this condition because it will contain small quantities of water. Alternatively the steam may pass to a super heater which is located within the boiler. Here