2.45GHz半有源标签接收机中的镜像抑制滤波器的分析.pdfVIP

ABSTRACT With so many advantages, including long communication distance and high data rate, RF tags in microwave band which have a very impressive prospect will be applied to the huge demand areas such aslogistics, networking, car networking and so on. Based on ISO/IEC18000-4 standard protocol, the study analyzes and designs a complex image rejection filter which is applied to the receiver of semi-active tags for 2.45GHz, and it meets the demand that image signal should be attenuated for low IF receiver. Firstly, the thesis introduces the development process and trend of RF tags, and analyzes the research progress of RF tags in microwave band. Then the wireless receivers with different structures are described from several aspects such as power, integration, noise and disorder. Next, the thesis gives a detailed account of the filter theory, including filters classification, approximation function and design methods. The theory of complex band-pass filter is described from the perspective of the low IF receiver architecture. And the mainstream filter structure of Active-RC and Gm-C are analyzed in detail. Finally, according to the protocol, the index of filter is determined, the schematic of Active-RC complex filter is designed in UMC 0.18μm,the simulation result shows as follows: center frequency is 2MHz, bandwidth is 1MHz,gain is 13.6dB, the adjacent channel (1MHz and 3MHz) attenuation is greater than 27dB, image rejection ratio is greater than 80dB,input third-order intercept point is about 17dBm,output noise is about 165nV/ and the static power dissipation is 13mW.The thesis emphasizes on the design of Biquad cascade of 6th order Butterworth complex ban