ICEM_Instructions由点生成面.pdfVIP

Instructions for creating a surface using point cloud data using ICEM Surf Start ICEM Enter Pick X (Close) File – New Windows – Licenses 1 Check mark boxes shown above File – Preview – Point Clouds Select .asc file (x,y,z cords in ascii format) or .csv file (from Rhino) will also work. You will be asked for a file name (where this is to be stored), then pick Format from the Import Preview box. 2 Set separation for Column using , (IE check the Column box and add a comma in the box as shown) then select the OK button. Ok in Input Preview dialog box should yield something similar to the following: Select Save, Preview Save dialog box appears. Pick Active and OK button. Pick OK button, then select Auto Min Max button from right side of screen to see points. If you don’t pick on the Auto Mix Max button, they will appear as tiny dots in the center of the screen. 3 Select Create (top of screen ) – Scan Triangulation Triangulation box appears, Pick on 3d, Optimize then Select. Selection (Object) dialog box highlights. Set a window around a few points and pick OK button in Selection dialog box. Picking OK in Triangulation dialog box yields something similar to the the following: Scan data (only) can then be exported as an stl file. Surface geometry cannot, it needs to have a scan applied to the surfaces first. You can write out a stl file by selecting File – Export and select stl. 4 It is possible to put x, y or Z planes through the object (ctrl-y) and then use Create – Curve – Approx, selecting these planes. This data can then be writ