罗格朗智能家居环境控制系统培训自动控制篇PART B.ppt

* 5- Configure the commands To configure the commands I have to put A and PL and also I have to Configure the modality of the commands by plugging in the blue configurators. Next slide: details of logics. * * * * Next slide: configurator M. * * Features of virtual configuration here; Next slide: logical configuration. * * There are different kinds of commands: Point-to-Point like shutters (in which I have to specify the kind of command) or lights (in which I haven’t got to put anything), Area command, Group command, General command. Next slide: scenario command. * Explain every single mode with examples. Next slide: same addresses. * 2 actuators with the same address cannot exist. You can’t give the same address to two actuators but you have to “call” one of them SLAVE (SLA), so the other one will be MASTER; the command arrives to the MASTER, and this gives the command to all its SLAVES (identified whit SLA). EX: ROMEO and ROMEO For example, if I have two friends whose name is Romeo and I want to call one of them and I say: ”ROMEO”, who of them will answer me? Just one, both or none of them? In the same way, with the BUS I can’t call two diffent devices with the same address but I can have ONE MASTER and ONE or MORE SLAVES. Next slide: THE END! * Next: limit. * Absorption : 1200mA (1000mA with 127V power supply) available from the power supply. Distance : 500m MAX of total cable, 250m MAX the length of the connection between power supply and farthest device. * Max cable stretch 500mt Max distance 250mtMax current available 1200mA * * These limits can be exceeded using the SCS/SCS interface art. LGR003562 * MOD=1 PHYSICAL EXPANSION It can increase the total BUS length or exceed the absorption limit of 1.2A for every power supply. It is possible to connect up to 4 interfaces in series, which subdivide the system into five distinct sections. No address assigned also functional; I3I4 must be configured for physical expansion; e.g. I3I4=32, then IN subsys