中心板的拆卸DisassemblyofmainPCB.doc

Maintenance Service Manual MODEL: EC-36 By Customer Service Department = 5 \* ROMAN V. Malfunction catalog Common Trouble and processing Methods are listed as follow: Serial NO. Phenomenon Description Maintenance Methods 01 No Function When Starting. 开机无功能 The LCD isn’t illuminating: LCD显示屏不亮 Fuse melts (in the Power Source Box or on the transformer wire). 保险丝断（在电源盒处或变压器导线上） ②Power supply circuit poorly connected. 电源电路接触不良 main PCB fails. 中心板坏 Replace Fuse. 更换保险丝 Replace Power Box. 更换电源盒 ③ Replace main PCB. 更换中心板 02 No function when starting. 开机无功能 The LCD is illuminating： LCD显示屏不亮 Mechanical switch fails or it’s wire is opened. 机械开关坏或机械开关的线材断开 Up or Down Stroke Photo-electricity fails. 上下行程光电坏 Main PCB fails. 中心板坏 Kneading is on without pressing any key when starting and no response by pressing other keys. 开机揉捏其他按键无效 Replace mechanical switch or its wire. 更换机械开关或机械开关线材 ②Replace Stroke Photo- electricity. 更换行程光电 Replace the main PCB. 更换PCB板 Width Inspection Board of PCB fails, replace it. 宽地检测板坏 更换宽度检测板 03 No Width switchover. 宽度无法切换 The terminals of Width Inspection on main PCB and wires are poorly connected. 中心板宽度检测端子线材接触不良 The terminals of Width Inspection on massage mechanical and wires are poorly connected. 机芯宽度检测板线材接触不良 Width Inspection fails. 宽度检测板坏 Main PCB fails. 中心板坏 ①②Plug the terminal securely or replace the wires. 端子接插到位或更换线材 Replace the Width Inspection. 更换宽度检测板 Replace the main PCB. 更换中心板 04 No Partial Function. 无区间功能 Height Inspection Terminal or wire poorly contacts. 高度检测板接线端或线材接触不良 Height Counting Subassembly fails. 高度计算组件坏 Plug the terminal securely or replace the wires. 把接线端插到位或跟换线材 Replace Height Counting Sub-assembly. 更换高度计算组件 05 No Rolling. 不行走 Terminal or Wire Poorly Contacts. 接线端或线材接触不良 ②Down-stroke Photo-electricity Subassembly Fails. 下行程光电组件坏 ③Up-stroke Photo-electricity Subassembly Fails. 上行程光电组件坏 Rolling Motor Fails. 行走电机坏 Main PCB Fails. 中心板坏 Plug the terminal securely or replace the wires. 将接线端插到位或更换线材 Replace Down-Stroke Sub