ICEM-CFD ProE参数建模集锦.ppt

Chevron流动模型中的传导圆柱 Create the section of the first gap Project Vertex-point Chevron流动模型中的传导圆柱 Create the section of the first gap Set location of vertices to points (this will aid in projecting normal) Chevron流动模型中的传导圆柱 Create the section of the first gap Project displayed to snap vertices to curves Chevron流动模型中的传导圆柱 Create the section of the first gap Split for outer conducting ring Project edge-curve to outer family, and Chevron family Set mesh parameters Make periodic nodes (this will aid in transformation) Chevron流动模型中的传导圆柱 Transform model Copy/Merge the topology -rotate the model for the given number of blades. Chevron流动模型中的传导圆柱 Finish the model Remove periodicity Project displayed to get nodes to snap to geometry Chevron流动模型中的传导圆柱 Finish the model Mesh model Write out mesh Check Replay file in Hexa, and MED Summary – Day Two Pro/E for Parametric Modeling Using Assemblies A closer look at ICEM CFD Hexa for Parametric Modeling Review (Q A) Summary – Day Three Review Tying it all together Scripting, etc. User examples Questions and Answers Reference CFD.prt In previous versions of Pro/E Mesher Interface, this was the recommended method. Chevron流动模型中的传导圆柱 (CFD.prt) Create the initial Pro/E model Methodology -CFD.prt (Assembly) Chevron流动模型中的传导圆柱 Create the Initial Assembly Assemble First Component Component-Assemble-select first part (chevron_outer.prt) -Open Create a New Assembly File-New-Assembly Name=Chevron_Assembly-OK Chevron流动模型中的传导圆柱 Create the Initial Assembly Assemble Second Component Component-Assemble-select second part (inner_ring.prt) -Open To place the second component in respect to the first, use the Coord Sys Constraint type, then select the CHEVRON_OUTER: CsO for the Assembly reference, and the INNER_RING:CsO for the Component reference-OK-Done/Return Chevron流动模型中的传导圆柱 Create the Initial Assembly Constrain the parts Offset needs to be adjusted so that inner ring fits inside Chevron Assembly-Modify-Mod Dim-Value-select the of