工厂中英文对照检讨报告.docVIP

中英文对照检讨报告 1成品平均肉厚为0.82左右. The average thickness is about 0.82mm. 2成品平均肉厚为0.6mm. The average thickness of part is 0.6mm. 3成品内厚均匀. The thickness of part is even. 4此处肉厚不均,成品易缩水.共六处.请修改. As the figure shows, the thickness is uneven, so it is easy to shrink. Please modify it, 6 areas in total. 5成品太薄,成型比较困难,请修改成品. The thickness of part is too thin, so it is difficult to be molded, please modify it. 6如图所示,塑件太薄请修改成品,厚度至少0.80mm As the figure shows, the thickness is too thin, please modify it to 0.8mm at least. 7如图所示,塑件太薄,不易充填,请将此处肉厚从0.40mm增加至0.50mm. As the figure shows, the thickness of part is too thi