加筋板静力分析.pptVIP

WS5-* NAS101, Workshop 5, February 2004 WORKSHOP 5 Stiffened Plate Subjected to Pressure Load Workshop 5 Stiffened Plate Model GOAL: model a stiffened panel using plate elements for the panel and BEAM elements for the stiffener Workshop 5 (cont.) Stiffened Plate Model We will model a plate which is 0.1 inches thick, 20.0 inches long, and 10.0 inches wide. The stiffener is shown below, along with the plate dimensions and loading The model has pinned supports at the corners Workshop 5 (cont.) Stiffened Plate Model Material properties: E = 10.3E+6 psi Poissons Ratio = .3 Density = .101 lb/in3 (weight density) The stiffener will be modeled using a BEAM with a PBEAML to define the cross-section The GRID points will lie at the mid-plane of the plate, so the BEAM must be offset from the GRID points by 1.05 (half the BEAM height pus half the plate thickness) Workshop 5 (cont.) Stiffened Plate Model Workshop 5 (cont.) Stiffened Plate Model PBEAML Entry PBEAML,2,1,,I ,2.,1.,1.,.1,.1,.1 Sample CBEAM CBEAM 21 2 31 32 0. 0. 1. 0. 0. 1.05 0. 0. 1.05 Workshop 5 (cont.) Stiffened Plate Model - Pressure Load Definition Pressure loads on plate and shell elements are defined using PLOAD2 or PLOAD4 entries SID = Static Loading Set ID EIDi = Element ID P = Pressure (applied in element coordinate system) PLOAD2,1,-.5,1,THRU,20 Workshop 5 (cont.) Suggested Exercise Steps: Create a finite element model of the plate made of CQUAD4 elements.The stiffener is made of BEAM element. Define material properties. (MAT1) Define element properties and sectional properties using the BEAM library. Apply loads and boundary conditions to the model. Submit the model to MSC.Nastran for analysis. Post-Process results using MSC.Patran. Create the first surface Geometry: Create / Surface / XYZ. Enter 20 5 0 for the Vector Coordinate List. Use [0 0 0] as the Origin Coordi