Mpcci 学习.docVIP

PAGE MpCCI 学习 首先启动MpCCI，配置完成后，在Go step中首先Start MpCCI，然后Start Fluent、Start Abaqus。 在fluent的开始界面中，首先initial，然后设置迭代参数，time step size 不但要与前面的abauqs的constant coupling time step相一致【应与abaqusEdit StepIncrementationInitial increment size相同】。 还要与MpCCICoupling StepGlobalQuantityConfigurationDefault value(s)一致。【注意：此处设置了DeltaTime为Global则在Go Step中，不能选中 Constant coupling time step，并指定the coupling time step size】 Fluent中Number of Time Steps=xxx；xxx*time step size与abaqusEdit StepBasicTime period相同。 ？？？？ When you create a coupled simulation project, the MpCCI GUI generates a set of files containing the definition of the coupled simulation model, e. g. the MpCCI input file and the MpCCI log files. Consequently, before you start the MpCCI GUI, you should move to a directory where you have permission to create files. You execute MpCCI GUI by running the mpcci executable with the gui subcommand and the desired options. Mpcci gui [OPTIONS] [project] [OPTIONS] Options: -chwd PATH Replace the symbolic working directory $(CWD) used inside the projectfile by the absolute pathname specified in the PATH argument. -new Start the GUI with a new project. Before starting a coupled simulation you have to establish a project by using the action Save As from the File menu. [开始模拟前，使用File menu中的Save as创建project。Project file产生input file，同时包含在MpCCI GUI中设置。] FileSave Project As saves the project settings under a speci_ed name. The MpCCI GUI displays the Save As dialog box. The active project can be renamed and saved to a new directory. To start an MpCCI job in batch mode with a well prepared coupled simulation project use: mpcci -batch project name If you start the MpCCI GUI without any options like mpcci gui the following default checks are performed: _ Check and preparation of your environment. _ A check of your secure shell rsa/dsa key files. If no rsa/dsa key files are found you will be asked to create them. _ Check for an existing project file in the current directory in or