美国材料协会标准 B21 - B 21M - 18 (2019).pdfVIP

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation: B21/B21M − 18 (Reapproved 2019) Standard Specification for Naval Brass Rod, Bar, and Shapes1 This standard is issued under the fixed designation B21/B21M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the U.S. Department of Defense. 1. Scope* B124/B124M Specification for Copper and Copper Alloy 1.1 This specification establishes the requirements for naval Forging Rod, Bar, and Shapes brass rod, bar, and shapes produced from Copper Alloy UNS B154 Test Method for Mercurous Nitrate Test for Copper Nos. C46200, C46400, C46750, C47940, C48200, C48500, or Alloys C48640. B249/B249M Specification for General Requirements for 1.1.1 For piston-finish rod or shafting refer to the Other Wrought Copper and Copper-Alloy Rod, Bar, Shapes and Requirements Section. Forgings 1.1.2 For hot forging material, refer to Speci