美国材料协会标准 A492 - 95 (2019).pdf

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation: A492 − 95 (Reapproved 2019) Standard Specification for Stainless Steel Rope Wire1 This standard is issued under the fixed designation A492; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. This standard has been approved for use by agencies of the U.S. Department of Defense. 1. Scope 3.1.6 Form (wire), 1.1 This specification covers the more commonly used types 3.1.7 Applicable dimensions (diameter), of round stainless steel wire intended especially for stranding 3.1.8 Type designation (Table 1), into wire rope. 3.1.9 ASTM designation and date of issue, and 3.1.10 Special requirements. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical 3.2 If possible, the intended end use of the item should be conversions to SI units that are provided for information only given on the purchase order, especially when the