美国材料协会标准 A814 - A 814M - 15 (2019).pdfVIP

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation: A814/A814M − 15 (Reapproved 2019) Standard Specification for Cold-Worked Welded Austenitic Stainless Steel Pipe1 This standard is issued under the fixed designation A814/A814M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. 1. Scope sions may be furnished provided such pipe complies with all other requirements of this specification. 1.1 This specification covers two classes of flanged and cold-bending quality cold-worked straight-seam single or 1.6 The values stated in either inch-pound units or SI units double welded austenitic steel pipe intended for high- are to be regarded separately as standard. Within the text, the temperature and general corrosive services. SI units are shown in brackets. The values stated in each NOTE 1—When the impact test criterion for a low-temperature service system are not exact equivalents; therefore, each system must would be 15 ft·lbf [20 J] energy absorption or 15 mils [0.38 mm] lateral be use