美国材料协会标准 B493 - B 493M - 14 (2019).pdf

This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. Designation: B493/B493M − 14 (Reapproved 2019) Standard Specification for Zirconium and Zirconium Alloy Forgings1 This standard is issued under the fixed designation B493/B493M; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision. A number in parentheses indicates the year of last reapproval. A superscript epsilon (´) indicates an editorial change since the last revision or reapproval. 1. Scope hammers, presses, or forging machines; a lot shall consist of a 1.1 This specification2 covers three grades of zirconium and material of the same size, shape, condition, and finish produced zirconium alloy forgings (see 4.1). from the same ingot or powder blend by the same reduction schedule and the same heat treatment parameters. Unless 1.2 The values stated in either SI units or inch-pound units otherwise agreed between manufacturer and purchaser, a lot are to be regarded separately as standard. The values stated in shall be limited to the product of an 8-h period for final each system may not be exact equivalents; therefore, each continuous anneal, or to a single furnace load for final batch