加工中心刀柄结构说明课件.pptVIP

加工中心刀柄结构说明;Two Face Contact HSK holders/两面接触HSK刀柄;Two Face Contact Holders/两面接触刀柄;Concentricity Balance/同心度和动平衡;Concentricity/同心度;Balance/动平衡;Balance Concentricity/动平衡和同心度;It is possible to imagine a tool / tool holder system that is balanced without being concentric. In this drawing, the cutting tool is off center, but the counterweight compensates for the resulting unbalance. This tool and tool holder may not cut evenly, but together they will spin without vibration from centrifugal force. 可以想象同心度不好的刀具刀夹系统也可以有好的动平衡。在图中，刀具中心偏移，但是图中的红色部位可以补偿因此带来的动不平衡量。虽然像这种刀具切削不能进行均匀的切削，但是不会因为动平衡离心力的影响产生震动。;It is also possible for a tool / tool holder system to be concentric but not balanced. A tool holder with a set screw is an example of this. Even if the tool holder holds the tool perfectly concentric, the weight of the screw itself would not be balanced. This tool holder will cause vibration when spun. 同样对于同心度好的刀具也可能动平衡不好。如图所示的带紧固螺钉的刀柄。虽然它有很好的同心度，但是它在圆周上的质量分部不均匀，因此在高速旋转时会产生震动。;Holders for Good Concentricity/优良同心度;Shrink Fit Holders/热缩型刀柄;Principle of shrink fit/热缩型刀柄装夹原理;Hydraulic Chucks/液压夹头;Mechanical Deformation/变形夹持刀柄;Balanceable Tool Holders;Comparison of Tool Holders/刀柄全面评估比对;Runout of Tool Holders/刀夹跳动;Rigidity of Tool Holders/刀柄刚性;Balance of Tool Holders/刀柄动平衡;Vibration of Tool Holders/刀柄震动;Ease of Use of Tool Holders/使用方便性;Cost of Tool Holders/成本;Other Types of Tool Holders/其他型式刀柄;Other types of Tool Holders/其他形式的刀柄;Overview of Tooling;THANKS