Windows命令行下配置IP地址.docxVIP

Windows命令行下配置IP地址 Sometimes the system is wrong, there is no local connection in the network connection, and the network card is norma1. There is no way to change the local IP address? Because usually modify IP in the local connection properties, but local connection is now cant see, un der the comma nd line with IPconfig can v i ew your IP address, but cannot be modified. In fact, we can configure the IP address at the command line, which is the NETSH command of the system. After my batch processing, you can modify the local connection IP address: @ echo off Set IP = 〃192.168.3. 100〃 / / set the IP address arbitrarily (the IP address and the connection name are enclosed in double quotation marks) Echo set IP address to % IP % The netsh interface IP set address name 二local cormection The source = static address = % IP number mask = 255. 255. 255. 0 Gateway = 192.168. 3. 177 Rem gwmetric = auto Echo 〃ok〃 Rem pause Common netsh commands: set up the Windows xp the IP address of the local connection for 10.223? 3. 254, subnet as 255? 255? 255? 0, gateway for 10. 223. 3. 1, jump points 1. C: \ netsh interface IP set the address name 二local area connectiorT source 二 static addr 二 10. 223. 3. 254 mask 255. 255. 255. 0 gateway of 二二 10. 223. 3. 1 Gwmetric 二 auto setting the IP address of Windows xp local connection automatically gets the C: \ netsh interface IP set address name 二local area connectiorT source 二 DHCP the DNS name for setting Windows xp local connectiorT is 10. 223? 3. 2 C: \ netsh interface IP set DNS name 二local area connection source 二 static addr 二 10.223.3.2 register 二 primary the DNS for setting up Windows xp local connectiorT is automatically obtained C: \ netsh interface IP set DNS name 二local area connection source 二 DHCP Attached: the netsh command configures the IP address and the detailed usage of DNS Add IP addresses and default gateways (add, reset or update the original IP address) Netsh add interface IP address Usage: add address [name 二]I