CFX培训教材05物理设置2.pptVIP

When a direct computation of the dependent variables can be made in terms of known quantities, the computation is said to be explicit. In contrast, when the dependent variables are defined by coupled sets of equations, and either a matrix or iterative technique is needed to obtain the solution, the numerical method is said to be implicit. the iteration steps usually do not correspond to a realistic time-dependent behavior. In fact, it is this aspect of an implicit method that makes it attractive for steady-state computations, because the number of iterations required for a solution is often much smaller than the number of time steps needed for an accurate transient that asymptotically approaches steady conditions. The principal reason for using implicit solution methods, which are more complex to program and require more computational effort in each solution step, is to allow for large time-step sizes. In an explicit numerical method S would be evaluated in terms of known quantities at the previous time step n. An implicit method, in contrast, would evaluate some or all of the terms in S in terms of unknown quantities at the new time step n+1. Since new quantities then appear on both the left and right side of the Q-equation, it is said to be an implicit definition of the new n+1 values. Usually a matrix or iterative solution must be used to compute the new quantities. unconditionally stable? This situation never occurs with explicit methods, which are always conditionally stable. * * A Pera Global Company ? PERA China A Pera Global Company ? PERA China ANSYS CFX 培训教材 第五节：物理设置（2） 安世亚太科技（北京）有限公司 交界面（Domain Interfaces）一般用于: 连接非匹配网格(如hex 与 tet的连接) 网格可以在相同/不同的domain里 一个简单的网格文件里可能包含非匹配网格区域，需要Interface进行连接 Domain间有不同的参考坐标系 即使网格匹配 连接不同类型的domain(如. Fluid 与Solid) 创建一个domain的周期性边界条件 交界面 插入 Domain Interfaces 右键点击Flow Analysis 创建domain的interface 或点击相应的工具栏按钮 Domain的Interface创建好了以后，目录树上出现3个新的对象 Interface对象处于Flow Analysis层面 编辑该Interface，改变Interface类型 在每个domain内，都有Sid