刘世龙马鞍山至芜湖高速公路设计说明书.docVIP

马鞍山至芜湖段高速公路PZ05合同段施工图设计 摘 要 本设计是安徽省马鞍山至芜湖的高速公路。主要内容包括：平面设计，纵断面设计，横断面设计，路基设计，边坡的确定，边沟设置，超高计算，不良地理的处理，路基的防护工程，沥青路面的设计，路面的计算，路基的排水设计，路面的排水设计，圆管涵的设计及计算。首先根据已知的设计任务书查找资料确定各项所需数据，经过交通量计算确定交通等级和设计车速；然后根据已知的各项条件进行路线的选择与确定，本段路共设两个交点分别为K1+369.92、K2+923.73，进而进行平曲线要素的计算并进行校核；其次纵断面设计，本设计路段共设计两个变坡点，4079Km范围内共设两个竖曲线；接下来是是横断面的设计，其中行车道宽为2×2×7.5米，中央分隔带2.0米，硬路肩2×3.0米（其中包括右侧路缘带0.5米），左侧路缘带2×0.75米，土路肩2× 关键词：高速公路；选线；平面设计；纵断面设计；排水设计；涵洞计算 Maanshan??to Wuhu section of?highway PZ05 contract section?construction drawing design Abstract The design of Anhui?province Maanshan?to Wuhu highway. The main?contents include: Graphic design, Vertical section design,?cross section design,?roadbed design,?slope,side ditch?isarranged,?high?calculation,?treatmentofadversegeographical,?roadbed?protection engineering,?design?ofasphaltpavement,?pavement?drainagedesign?calculation,?subgrade,pavement?drainage?design,?design and calculation of?pipe culvert.First?of all required?data is determined?according tothe?design taskbook to find the?information?known,?the?traffic volume?calculation to determine the?traffic grade?and?design speed;?and?then determineroute?according to the?conditions of?known?choice,?this?section of the road?a total of?two intersections?are respectively K1+369.92,K2+923.73,?and calculate?and?elements of horizontal curve?is checked;?secondly,?the vertical section design,?the design of?sectiondesign of two?grade,?4079Km range?consists of two?vertical curve;?the next?is the?cross-sectional design,?the?lane?width is 2?x 2 x?7.5 meters,2 meters?in central separate belt,?hard shoulder?2 x?3 meters(including?0.5?on the right side of?road edge?meters),?left?the edge of the road?with 2 x?0.75 meters,?soil shoulder 2?x 0.75 meters;?designand then there is the?roadbed,?roadbed design?include: the design ofsubgrade?slope?height determination,?determination,?design and calculation of?side ditch?and?super high?and bad?road;?in the next?is the?correlation calculation?design?and road?pavement;?anoth