表4.4.1方(矩)形管道检验批施工质量验收表.docVIP

PAGE 方（矩）形管道检验批施工质量验收表 ?inspection of construction quality test table 机组 工程编号Project number： 性质property： 表4.4.1 分项工程名称 Name of Sub-item project 序号Sr. 检 验 项 目Inspection items 性质property 单位unit 质量标准Quality standard 质量检验结果The quality inspection results 结论conclusion 1 原材料品种、规格、性能?type，specifications，performance of raw material? 主控main control 应符合现行国家产品标准和设计要求。进口钢材产品质量应符合设计要求和合同规定标准的规定Products should be consistent with existing national standards and design requirements. Quality of imported steel products should comply with the design requirements and provisions of the standard stipulated in the contract 2 原材料尺寸偏差Size deviation of raw material 应符合产品标准的规定Should comply with the regulations of the product standard 3 原材料表面外观质量The appearance quality of the raw material surface 应符合现行有关标准的规定Should comply with the terms of the current relevant standards 4 截面边长偏差Cross section length deviation mm ±L1/500，且and≤4 5 截面两对角线差 主控main control mm ≤L1/250，且and≤8 6 两端面与轴线垂直度偏差two end face and axis verticality deviation mm ≤L1/100，且and≤5 7 管道长度偏差 mm 0～L2/500，且and≤10 8 管道直线度偏差straightness deviation 主控main control mm ≤L2/500，且and≤6 9 对口错边量align deviation value s.≤10 mm ≤1 s.＞10 ≤0.1s 10 表面平面度偏差surface flatness deviation s.≤5 mm/m ≤8 s.＞5 ≤5 11 加固筋位置偏差strengthening ribposition deviation mm ≤5 12 内支撑相对于加固筋中心位置偏差 mm ≤5 13 焊接 welding 焊接材料的品种、规格、性能type, specification, performance of welding material 主控main control 应符合设计要求和现行国家产品标准的规定Should comply with the design requirements and the provisions of the existing national product standards 14 接头表面质量joint surface quality 焊缝尺寸weld seam size 主控main control 应符合设计要求Should comply with the design requirements 15 焊缝成型weld seam formation 焊缝过渡圆滑，接头良好weld seam transits smoothly, and joint well 16 裂纹、气孔和夹渣flaw, crater, blowhole and slag inclusion 无no 17 严密性 主控main control 无渗漏no leakage 18 油漆paint 油漆的品种、规格、性能?type ，specifications，performance of paint 主控main control 应符合设计要求和现行国家产品标准的规定Should comply wi